Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A193/A193M-23
Standard Specification for Alloy-Steel and Stainless Steel Bolting for High Temperature or High Pressure Service and Other Special Purpose Applications
Translate name
STANDARD published on 1.3.2023
The information about the standard:
Designation standards: ASTM A193/A193M-23
Note: WITHDRAWN
Publication date standards: 1.3.2023
SKU: NS-1135555
The number of pages: 14
Approximate weight : 42 g (0.09 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A193/A193M-23 :
Keywords:
alloy steel bars, alloy steel bolting, bolting components, bolting materials, hardness, heat treatment, stainless steel bolting,, ICS Number Code 21.060.01 (Fasteners in general),77.080.20 (Steels)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1?This specification1.2?Several grades are covered, including ferritic steels and austenitic stainless steels designated B5, B8, and so forth. Selection will depend upon design, service conditions, mechanical properties, and high temperature characteristics. 1.3?The following referenced general requirements are indispensable for application of this specification: Specification A962/A962M. Note 1:?The committee formulating this specification has
included several steel types that have been rather extensively used
for the present purpose. Other compositions will be considered for
inclusion by the committee from time to time as the need becomes
apparent.
Note 2:?For grades of alloy-steel bolting suitable for use at
the lower range of high temperature applications, reference should
be made to Specification A354.
Note 3:?For grades of alloy-steel bolting suitable for use in
low temperature applications, reference should be made to
Specification A320/A320M.
1.4?Nuts for use with bolting are covered in Section 13. 1.5?Supplementary Requirements are provided for use at the option of the purchaser. The supplementary requirements shall apply only when specified in the purchase order or contract. 1.6?This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable 1.7?The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.8?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
