Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A319-71(2020)
Standard Specification for Gray Iron Castings for Elevated Temperatures for Non-Pressure-Containing Parts
Translate name
STANDARD published on 1.5.2020
The information about the standard:
Designation standards: ASTM A319-71(2020)
Note: WITHDRAWN
Publication date standards: 1.5.2020
SKU: NS-992983
The number of pages: 2
Approximate weight : 6 g (0.01 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A319-71(2020) :
Keywords:
chemical composition, elevated temperature, gray iron, iron castings, non-pressure containing, tensile strength ,, ICS Number Code 77.140.80 (Iron and steel castings)
Additional information
| 1. Scope | ||
|
1.1 This specification covers three classes of gray iron suitable for castings exposed to temperatures encountered in such service as grate bars, stoker links, stoker parts, oil still furnace parts, firebox parts, ingot molds, glass molds, caustic pots, and metal melting pots. Note 1: This specification is general, covering cast irons
normally used for the above types of service, at temperatures as
high as 1400 °F (760 °C). It is not intended to imply that all
three classes are suitable throughout this entire temperature range
without regard to actual service stresses. Some are suitable for
long service at the lower temperatures only, unless low stresses
are involved.
1.2 The three classes of gray iron covered by this specification are as follows: 1.2.1 Class I, possessing superior resistance to thermal shock, 1.2.2 Class II, possessing average resistance to thermal shock and a moderately good tensile strength (tensile strengths above 30 000 psi (207 MPa) may be expected), and 1.2.3 Class III, possessing a higher tensile strength than either Class I or II (tensile strengths as high as 40 000 psi (276 MPa) may be expected). 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
| 2. Referenced Documents | ||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
