Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A370-14
Standard Test Methods and Definitions for Mechanical Testing of Steel Products
STANDARD published on 15.5.2014
The information about the standard:
Designation standards: ASTM A370-14
Note: WITHDRAWN
Publication date standards: 15.5.2014
SKU: NS-2265
The number of pages: 50
Approximate weight : 150 g (0.33 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A370-14 :
Keywords:
bend test, Brinell hardness, Charpy impact test, elongation, FATT (Fracture Appearance Transition Temperature), hardness test, portable hardness, reduction of area, Rockwell hardness, tensile strength, tension test, yield strength, ICS Number Code 77.040.10 (Mechanical testing of metals), 77.140.01 (Iron and steel products in general)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||
|
1.1 These test methods1.2 The following mechanical tests are described:
1.3 Annexes covering details peculiar to certain products are appended to these test methods as follows:
1.4 The values stated in inch-pound units are to be regarded as the standard. 1.5 When this document is referenced in a metric product specification, the yield and tensile values may be determined in inch-pound (ksi) units then converted into SI (MPa) units. The elongation determined in inch-pound gauge lengths of 2 or 8 in. may be reported in SI unit gauge lengths of 50 or 200 mm, respectively, as applicable. Conversely, when this document is referenced in an inch-pound product specification, the yield and tensile values may be determined in SI units then converted into inch-pound units. The elongation determined in SI unit gauge lengths of 50 or 200 mm may be reported in inch-pound gauge lengths of 2 or 8 in., respectively, as applicable. 1.6 Attention is directed to ISO/IEC 17025 when there may be a need for information on criteria for evaluation of testing laboratories. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
