Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A456/A456M-08(2023)
Standard Specification for Magnetic Particle Examination of Large Crankshaft Forgings
Translate name
STANDARD published on 15.3.2023
The information about the standard:
Designation standards: ASTM A456/A456M-08(2023)
Note: WITHDRAWN
Publication date standards: 15.3.2023
SKU: NS-1137687
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A456/A456M-08(2023) :
Keywords:
acceptance criteria, barrel forged crankshaft, crankshaft forgings, magnetic particle examination, nondestructive examination, slab forged crankshaft,, ICS Number Code 77.140.85 (Iron and steel forgings)
Additional information
| 1. Scope | ||||||||||||
|
1.1?This is an acceptance specification for the magnetic particle inspection of forged steel crankshafts having main bearing journals or crankpins 4 in. [200 mm] or larger in diameter. 1.2?There are three classes, with acceptance standards of increasing severity: 1.2.1?Class 1. 1.2.2?Class 2 (originally the sole acceptance standard of this specification). 1.2.3?Class 3 (formerly covered in Supplementary Requirement S1 of Specification A456 64 (1970)). 1.3?This specification is not intended to cover continuous grain flow crankshafts (see Specification A983/A983M); however, Specification A986/A986M may be used for this purpose. Note 1:?Specification A668/A668M is a product specification
which may be used for slab-forged crankshaft forgings that are
usually twisted in order to set the crankpin angles, or for barrel
forged crankshafts where the crankpins are machined in the
appropriate configuration from a cylindrical forging.
1.4?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5?Unless the order specifies the applicable M specification designation, the material shall be furnished to the inch units. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
| 2. Referenced Documents | ||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
