We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe
STANDARD published on 1.5.2012
Designation standards: ASTM A530/A530M-12
Note: WITHDRAWN
Publication date standards: 1.5.2012
SKU: NS-3007
The number of pages: 9
Approximate weight : 27 g (0.06 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
alloy steel pipe, carbon steel pipe, general delivery requirements, steel pipe, ICS Number Code 23.040.10 (Iron and steel pipes)
1. Scope | ||||||||||||||||||||||||||||||||
1.1 This specification covers a group of requirements which, with the exceptions of Section 6.3, Section 14, Section 21, and Section 22, are mandatory requirements to the ASTM pipe product specifications noted below unless the product specification specifies different requirements, in which case the requirement of the product specification shall prevail. 1.2 Sections 6.3 or 21 are mandatory if the product specification has a requirement for product analysis or flattening tests. 1.3 Section 22 is mandatory if the product specification has a hydrostatic test requirement without defining the test parameters. 1.4 Section 14 is for information only. 1.5 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification, only the requirement of the product specification need be satisfied.
A These designations refer to the latest issue of the respective specifications. 1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order. Note 1—The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as “nominal diameter,” “size,” and “nominal size.” 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||
|
Historical
1.3.2012
Historical
1.10.2013
Historical
1.3.2014
Historical
1.5.2010
Historical
1.5.2014
Historical
1.3.2007
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-12-13 (Number of items: 2 215 533)
© Copyright 2024 NORMSERVIS s.r.o.