Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A675/A675M-14
Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality, Mechanical Properties
STANDARD published on 1.5.2014
The information about the standard:
Designation standards: ASTM A675/A675M-14
Note: WITHDRAWN
Publication date standards: 1.5.2014
SKU: NS-3647
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A675/A675M-14 :
Keywords:
carbon steel bars, hot-wrought steel bars, steel bars, ICS Number Code 77.140.60 (Steel bars and rods)
Additional information
| 1. Scope | ||||||||
|
1.1 This specification2 covers hot-wrought special quality carbon steel bars and bar size shapes produced to mechanical property requirements and intended for general constructional applications. 1.2 The bars are available in nine strength grades designated 45, 50, 55, 60, 65, 70, 75, 80, and 90 [310, 345, 380, 415, 450, 485, 515, 550, and 620] corresponding to the minimum ultimate tensile strength in ksi [MPa]. The chemical composition is selected by the manufacturer to develop the required mechanical properties. 1.3 Hot-wrought special quality carbon steel bars subject to mechanical property requirements are hot wrought in straight lengths only. Sections and sizes available are covered in Specification A29/A29M. 1.4 Some applications may require one or more of the available designations shown under Supplementary Requirements. 1.5 The values stated in either SI
units or inch-pound units are to be regarded separately as
standard. The values stated in each system may not be exact
equivalents; therefore, each system shall be used independently of
the other. Combining values from the two systems may result in
non-conformance with the standard.
|
||||||||
| 2. Referenced Documents | ||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
