Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A727/A727M-13
Standard Specification for Carbon Steel Forgings for Piping Components with Inherent Notch Toughness
STANDARD published on 1.10.2013
The information about the standard:
Designation standards: ASTM A727/A727M-13
Note: WITHDRAWN
Publication date standards: 1.10.2013
SKU: NS-3900
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A727/A727M-13 :
Keywords:
carbon equivalent, pipe fittings, steel, piping applications, pressure containing parts, steel flanges, steel forgings, carbon, steel valves, temperature service applications, low, ICS Number Code 77.140.85 (Iron and steel forgings)
Additional information
| 1. Scope | ||||||||
|
1.1 This specification2 covers forged carbon steel piping components intended primarily for service in pressure piping systems from −20 to +650 °F [−30 to +345 °C] where inherent notch toughness is desired, but where notch toughness testing is not required. Included are forged or ring-rolled flanges, forged fittings, and valves made to specified dimensions, or to dimensional standards such as the ASME and API specifications referenced in Section 2. 1.2 This specification is limited to forgings with maximum finished section thicknesses no larger than 2 in. [51 mm]. 1.3 It shall be the responsibility of the purchaser to determine whether material meeting the requirements of this specification is satisfactory for the service application. 1.4 Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified by the purchaser in the order. 1.5 This specification is expressed
in both inch-pound units and in SI units. However, unless the order
specifies the applicable “M” specification designation (SI units),
the material shall be furnished to inch-pound units.
1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||
| 2. Referenced Documents | ||||||||
|
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
