Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A971-00
Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils
STANDARD published on 10.7.2000
The information about the standard:
Designation standards: ASTM A971-00
Note: WITHDRAWN
Publication date standards: 10.7.2000
SKU: NS-5117
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A971-00 :
Keywords:
coupon, crown, edge taper, edge trim, gamma strip, master coil, slit coil, ICS Number Code 77.140.50 (Flat steel products and semi-products)
Additional information
| 1. Scope |
|
1.1 This test method provides a procedure for measuring edge taper and crown of flat-rolled electrical steel coils as produced at the steel mill. 1.2 The values stated in either customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method. 1.3 The following material specifications include requirements for edge taper or crown: A677, A677M, A683/A683M, A726, A840, A840M, and A876/A876M. 1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
