We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Method for Non-Destructive Photoelastic Measurement of Edge and Surface Stresses in Annealed, Heat-Strengthened, and Fully Tempered Flat Glass
STANDARD published on 1.10.2013
Designation standards: ASTM C1279-13
Note: WITHDRAWN
Publication date standards: 1.10.2013
SKU: NS-10439
The number of pages: 11
Approximate weight : 33 g (0.07 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
annealed glass, heat-strengthened glass, polariscopic examination, stress measurement, tempered glass, ICS Number Code 81.040.20 (Glass in building)
Significance and Use | ||||||||||||||
5.1 The strength and performance of heat-strengthened and fully-tempered glass is greatly affected by the surface and edge stress induced during the heat-treating process. 5.2 The edge and surface stress levels are specified in Specification C1048, in the Engineering Standards Manual5.3 This test method offers a direct and convenient way to non-destructively determine the residual state of stress on the surface and at the edge of annealed and heat-treated glass. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This test method covers the determination of edge stresses and surface stresses in annealed, heat-strengthened, and fully tempered flat glass products. 1.2 This test method is non-destructive. 1.3 This test method uses transmitted light and is, therefore, applicable to light-transmitting glasses. 1.4 The test method is not applicable to chemically-tempered glass. 1.5 Using the procedure described, surface stresses can be measured only on the “tin” side of float glass. 1.6 Surface-stress measuring instruments are designed for a specific range of surface index of refraction. 1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historical
1.10.2011
Historical
1.3.2012
Historical
1.6.2012
Historical
1.10.2011
Historical
1.5.2014
Historical
1.3.2010
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2025-01-10 (Number of items: 2 218 439)
© Copyright 2025 NORMSERVIS s.r.o.