We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Method for Surface Infiltration Rate of Permeable Unit Pavement Systems
Translate name
STANDARD published on 1.12.2021
Designation standards: ASTM C1781/C1781M-21
Publication date standards: 1.12.2021
SKU: NS-1044301
The number of pages: 6
Approximate weight : 18 g (0.04 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
clay paving units, concrete grid paving units, concrete paving units, infiltration, permeable, unit pavement systems, water,, ICS Number Code 93.080.20 (Road construction materials)
Significance and Use | ||||||||||||||||
5.1?This test method can be used for acceptance of surface infiltration of new permeable unit pavement systems. 5.2?Tests performed at the same location across a span of years may be used to detect a reduction of infiltration rate of the permeable surface, thereby identifying the need for any remedial maintenance intended to increase the infiltration rates to predefined levels. 5.3?The infiltration rate obtained by this method is valid only for the localized area of the pavement where the test is conducted. To determine the surface infiltration rate of the entire permeable pavement, multiple locations must be tested and the results averaged. 5.4?The minimum acceptable infiltration rate is typically established by the design engineer of record or the municipality and can be a function of the design precipitation event. 5.5?This test method can also be used to demonstrate the infiltration rate of a particular permeable unit pavement system if the drainage joints are filled with the aggregate that is specified for use in that system. |
||||||||||||||||
1. Scope | ||||||||||||||||
1.1?This test method covers the determination of the field surface infiltration rate of in place permeable unit pavement systems surfaced with solid interlocking concrete paving units, concrete grid paving units, or clay paving brick. Note 1:?For in-place pervious concrete, Test Method
C1701/C1701M should be used.
Test Method C1701/C1701M is
functionally identical to this standard, but does not include the
added provisions for positioning and securing the test ring to a
discontinuous surface, which are detailed in this standard. Both
tests methods give comparable results
1.2?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3?The text of this test method references notes that provide explanatory material. These notes shall not be considered as requirements of the test method. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
2. Referenced Documents | ||||||||||||||||
|
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
Latest update: 2024-09-28 (Number of items: 2 350 600)
© Copyright 2024 NORMSERVIS s.r.o.