Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM C443M-21
Standard Specification for Joints for Concrete Pipe and Manholes, Using Rubber Gaskets (Metric)
Translate name
STANDARD published on 1.10.2021
The information about the standard:
Designation standards: ASTM C443M-21
Publication date standards: 1.10.2021
SKU: NS-1041945
The number of pages: 6
Approximate weight : 18 g (0.04 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM C443M-21 :
This specification covers flexible watertight joints for concrete pipe and precast manhole sections, using rubber gaskets for sealing the joints, where infiltration or exfiltration is a factor in the design. The numerical values in this specification are not presented in inch-pound units, but rather, in metric or SI units only. All rubber gaskets shall meet the dimensions, tolerances, and physical requirements of both standard gasket and oil resistant gasket requirements. Assembled joints should pass the following performance test without leakage at the joints: pipes in straight alignment, and pipes in maximum deflected position.
Keywords:
concrete pipe, joints, manhole, rubber gaskets ,, ICS Number Code 13.060.30 (Sewage water)
Additional information
| 1. Scope | ||||||||||||
|
1.1?This specification covers flexible leak-resistant joints for concrete pipe and precast manhole sections, using rubber gaskets for sealing the joints, where infiltration or exfiltration is a factor in the design. The specification covers the design of joints and the requirements for rubber gaskets to be used therewith, for pipe conforming in all other respects to Specification C14M, Specification C76M, or Specification C507M and precast manhole section conforming in all other respects to Specification C478M, provided that if there is conflict in permissible variations in dimensions, the requirements of this specification for joints shall govern. 1.2?This specification is the metric counterpart of Specification C443. Note 1:?This specification covers the design and performance
of the rubber gasket joint only. Joints covered by this
specification are adequate for hydrostatic pressures up to 90 kPa
(9 m), when tested per Section 9. Infiltration or exfiltration
quantities for an installed pipeline are dependent upon many
factors other than the joints, and allowable quantities must be
covered by other specifications and suitable testing of the
installed pipeline and system.
1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
| 2. Referenced Documents | ||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
