ASTM E1623-11
ASTM E2178-13
ASTM E2768-11
ASTM E329-14a
ASTM E84-14
ASTM G162-99(2010)..
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM C566-13
Standard Test Method for Total Evaporable Moisture Content of Aggregate by Drying
STANDARD published on 1.2.2013
The information about the standard:
Designation standards: ASTM C566-13
Note: WITHDRAWN
Publication date standards: 1.2.2013
SKU: NS-14044
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM C566-13 :
Keywords:
aggregate, drying, moisture content, ICS Number Code 91.100.01 (Construction materials)
Additional information
| Significance and Use | ||||||||||||||||
|
4.1 This test method is sufficiently accurate for usual purposes, such as adjusting batch quantities of ingredients for concrete. It will generally measure the moisture in the test sample more reliably than the sample can be made to represent the aggregate supply. In cases where the aggregate itself is altered by heat, or where more refined measurement is required, the test should be conducted using a ventilated, controlled temperature oven. 4.2 Large particles of coarse aggregate, especially those larger than 50 mm, will require greater time for the moisture to travel from the interior of the particle to the surface. The user of this test method should determine by trial if rapid drying methods provide sufficient accuracy for the intended use when drying large size particles. |
||||||||||||||||
| 1. Scope | ||||||||||||||||
|
1.1 This test method covers the determination of the percentage of evaporable moisture in a sample of aggregate by drying both surface moisture and moisture in the pores of the aggregate. Some aggregate may contain water that is chemically combined with the minerals in the aggregate. Such water is not evaporable and is not included in the percentage determined by this test method. 1.2 The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.3 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
|
|
Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials (Includes all amendments and changes 3/11/2024).
|
|
Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves
|
National Research Council Report SHRP-P-619 Available from the National Research Council, 2101 Constitution Ave., N.W., Washington, DC 20418.
|
|
|
Standard Test Method for Bulk Density (“Unit Weight”) and Voids in Aggregate
|
|
Standard Practice for Sampling Aggregates
|
|
Standard Terminology Relating to Concrete and Concrete Aggregates (Includes all amendments and changes 10/14/2021).
|
|
Standard Test Method for Relative Density (Specific Gravity) and Absorption of Coarse Aggregate (Withdrawn 2024)
|
|
Standard Test Method for Relative Density (Specific Gravity) and Absorption of Fine Aggregate |
Similar standards:
Historical
1.1.2011
Historical
1.2.2013
Historical
1.7.2011
Historical
1.6.2014
Historical
1.4.2014
Historical
1.2.2010
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
