Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D115-17
Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
Translate name
STANDARD published on 1.11.2017
The information about the standard:
Designation standards: ASTM D115-17
Note: WITHDRAWN
Publication date standards: 1.11.2017
SKU: NS-800746
The number of pages: 9
Approximate weight : 27 g (0.06 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D115-17 :
Keywords:
build, dielectric strength, drainage, flash point, nonvolatile matter, oil resistance, solvent varnish, specific gravity, temperature index, time of drying, varnish, varnish compatibility, viscosity,, ICS Number Code 29.035.60 (Varnished fabrics)
Additional information
| Significance and Use | ||||||||||||||||||||||||||||||||||||||
|
4.1 Control—The following tests are useful for control purposes during the manufacture and use of varnishes, and for determining the uniformity of batches: 4.1.1 Specific gravity, 4.1.2 Viscosity, 4.1.3 Flash point, and 4.1.4 Nonvolatile matter by weight. 4.2 Performance—The following tests are useful for determining the performance of varnishes during application and use: 4.2.1 Drainage, 4.2.2 Time of drying, 4.2.3 Build, 4.2.4 Dielectric strength, 4.2.5 Thermal endurance, 4.2.6 Varnish compatibility, 4.2.7 Salt water proofness, and 4.2.8 Oil resistance. |
||||||||||||||||||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||||||||||||||||||
|
1.1 These test methods cover tests for solvent containing varnishes primarily intended to provide electrical, mechanical, and chemical protection for electrical equipment. These test methods include tests for control and performance as follows:
1.2 Where the entire test method is included in this standard, the precision and bias are not known unless given in the stated method. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no equivalent IEC standard. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
