Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D3910-21
Standard Practices for Design, Testing, and Construction of Slurry Seal
Translate name
STANDARD published on 1.11.2021
The information about the standard:
Designation standards: ASTM D3910-21
Note: WITHDRAWN
Publication date standards: 1.11.2021
SKU: NS-1043769
The number of pages: 8
Approximate weight : 24 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D3910-21 :
Keywords:
abrasion resistance, appropriate ratio-mix formula, emulsified asphalt cold mixture, fine-graded aggregate, mineral filler, mixing water, set and cure time, slurry seal, slurry seal consistency, specialized mixing and application equipment,, ICS Number Code 93.080.10 (Road construction)
Additional information
| Significance and Use | ||||||||||||||||||
|
4.1?These slurry seal practices are written as a guide and should not be construed as specifications. 4.2?End-use specifications should be adopted to conform to job and user requirements. Note 1:?The quality of the results produced by this standard
are dependent on the competence of the personnel performing the
procedure and the capability, calibration, and maintenance of the
equipment used. Agencies that meet the criteria of Specification
D3666 are generally
considered capable of competent and objective testing, sampling,
inspection, etc. Users of this standard are cautioned that
compliance with Specification D3666 alone does not completely ensure
reliable results. Reliable results depend on many factors;
following the suggestions of Specification D3666 or some similar acceptable
guideline provides a means of evaluating and controlling some of
those factors.
|
||||||||||||||||||
| 1. Scope | ||||||||||||||||||
|
1.1?These practices cover the design, testing, and construction of mixtures for surface treatment of pavements. It is written as a guide and should be used as such. End-use specifications should be adapted to conform to job and user requirements. 1.2?The values stated in SI units are to be regarded as the standard. The non-SI units used in this standard are allowed by the subcommittee for clarification in the use of the standard. 1.3?The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
