ASTM C1516-05(2011)..
ASTM D6213-97(2009)..
ASTM D6662-13
ASTM E1730-09
ASTM E2110-11
ASTM E2134/E2134M-14..
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D4016-14
Standard Test Method for Viscosity and Gel Time of Chemical Grouts by Rotational Viscometer (Laboratory Method) (Withdrawn 2023)
Automatically translated name:
Standard Test Method for Viscosity and Gel Time of Chemical Grouts by Rotational Viscometer (Laboratory Method)
STANDARD published on 15.6.2014
The information about the standard:
Designation standards: ASTM D4016-14
Note: WITHDRAWN
Publication date standards: 15.6.2014
SKU: NS-25736
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D4016-14 :
Keywords:
chemical grout, coefficient of viscosity, gel point, grouting, Newtonian fluids, non-Newtonian fluids, rotational viscometer, viscosity, ICS Number Code 91.100.99 (Other construction materials)
Additional information
| Significance and Use | ||||||||
|
5.1 This test is intended for materials that will penetrate soil voids and rock fissures. Viscosity alone is not necessarily an exact index of grout penetrability. |
||||||||
| 1. Scope | ||||||||
|
1.1 This test method covers the determination of viscosity of catalyzed chemical grouts with a rotational viscometer (laboratory method), over the range from 1.0 mPa·s to 1000 mPa·s (1.0 to 1000 cP). 1.2 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026. 1.2.1 The procedures used to specify how data are collected/recorded or calculated, in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose of obtaining the data, special purpose studies, or any consideratons for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design. 1.3 The values stated in SI units are the standard. Other units provided in parentheses are for the convenience of the user. 1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
| 2. Referenced Documents | ||||||||
|
Similar standards:
Historical
1.12.2011
Historical
1.6.2009
Historical
1.6.2013
Historical
1.11.2009
Historical
1.11.2011
Historical
1.4.2014
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
