ASTM D7489-09(2013)..
ASTM D7490-13
ASTM D7539-10
ASTM D7588-11
ASTM D772-86(2011)..
ASTM D7733-12
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D4082-10
Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Nuclear Power Plants
STANDARD published on 15.5.2010
The information about the standard:
Designation standards: ASTM D4082-10
Note: WITHDRAWN
Publication date standards: 15.5.2010
SKU: NS-25969
The number of pages: 2
Approximate weight : 6 g (0.01 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D4082-10 :
Keywords:
coatings, gamma radiation effects, irradiation accumulated dose, irradiation dose rate, Irradiance/irradiation--paints/related coatings/materials, Nuclear reactor vessels--coatings applications, Radiation exposure, Gamma radiation, ICS Number Code 87.040 (Paints and varnishes)
Additional information
| Significance and Use | ||||||||||||||
|
This test method is designed to provide a uniform test to assess the suitability of coatings, used in nuclear power facilities, under radiation exposure for the life of the facilities, including radiation during a DBA (Coating Service Level I areas only). Specific plant radiation exposure may exceed or be less than the amount specified in 7.2 of this standard. If required by the licensee design basis, the gamma dose used may exceed the actual anticipated plant gamma dose to account for beta dose. Coatings in Level II and III areas (outside primary containment) are expected to be exposed to lower accumulated radiation doses. |
||||||||||||||
| 1. Scope | ||||||||||||||
|
1.1 This test method covers a standard procedure for evaluating the lifetime radiation tolerance of coatings to be used in nuclear power plants. This test method is applicable to Coating Service Levels I, II, and III. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. |
||||||||||||||
| 2. Referenced Documents | ||||||||||||||
|
Similar standards:
Historical
1.7.2013
Historical
1.7.2013
Historical
1.7.2010
Historical
1.6.2011
Historical
1.11.2011
Historical
1.2.2012
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
