ASTM D5071-06(2021)

4.1?Materials made from photodegradable plastics are intended to deteriorate rapidly when exposed to solar radiation, oxygen, heat, moisture and other degrading elements of the weather. This practice is used for evaluating the photodegradability of plastics when exposed in an apparatus that produces simulated daylight (4.2?Variations in results can be expected when operating conditions are varied within the accepted limits of this practice. Therefore, all test results using this practice must be accompanied by the specific operating conditions required in Section 9. Refer to Practice G151 for detailed information on the caveats applicable to use of results obtained in accordance with this practice.

4.3?The results of laboratory exposure cannot be directly extrapolated to estimate absolute rate of deterioration by the environment because the acceleration factor is material dependent and can be significantly different for each material and for different formulations of the same material. However, exposure of a similar material of known outdoor performance, a control, at the same time as the test specimens allows comparison of the durability relative to that of the control under the test conditions. Evaluation in terms of relative durabilities also greatly improves the agreement in test results among different laboratories (3).

4.4?Test results will depend on the care that is taken to operate the equipment in accordance with Practice G155. Significant factors include regulation of line voltage, freedom from salt or other deposits from water, temperature and humidity control and condition and age of the burners and filters.

4.5?Before proceeding with this practice, it is common practice to reference the specifications of the material being tested. Any test specimen preparation, conditioning, dimensions, or testing parameters, or combination thereof, covered in the material specification shall take precedence over those mentioned in this practice. If there are no material specifications, then the default conditions apply.

1.1?This practice covers specific procedures and test conditions that are applicable for xenon arc exposure of photodegradable plastics conducted in accordance with Practices G151 and G155. This practice also covers the preparation of test specimens, the test conditions best suited for photodegradable plastics, and the evaluation of test results.

1.2?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.