ASTM D5330/D5330M-06(2012)

The pressure-sensitive, filament-reinforced tapes covered by this specification are intended for use in closing and reinforcing fiberboard boxes and for bundling items for shipment.

Type I is an impact and cut-resistant low-tensile strength tape, usually with polyester fiber reinforcement. It is intended for bundling and similar applications and used where a greater amount of stretch before break provides an improvement in impact resistance over glass filament reinforcement.

Types II and III are intended for reinforcement of RSC's and similar fiberboard boxes, and for bundling where a snug bundle must be maintained and other similar applications.

Type IV is intended for applications in which weather-resistance high-tensile strength tape is required.

See Practice D1947 for details on applications.

1.1 This specification covers filament-reinforced, pressure-sensitive adhesive tape.

1.2 The values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore each system must be used independently of the other, without combining values in any way.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.