ASTM D5823-13
ASTM D5848-10e1
ASTM D6119-12
ASTM D6283-12
ASTM D6325-98(2011)..
ASTM D6333-10
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D5793-13
Standard Test Method for Binding Sites per Unit Length or Width of Pile Yarn Floor Coverings
STANDARD published on 1.7.2013
The information about the standard:
Designation standards: ASTM D5793-13
Note: WITHDRAWN
Publication date standards: 1.7.2013
SKU: NS-32567
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D5793-13 :
Keywords:
binding sites, carpet, construction, floor covering, pile yarn, ICS Number Code 97.150 (Floor coverings)
Additional information
| Significance and Use | ||||||||||||||||
|
5.1 This test method is useful in quality and cost control during manufacture. Both appearance and performance of pile yarn floor coverings can be affected by the number of binding sites per length and width. 5.2 This test method is considered satisfactory for acceptance testing of commercial shipments because current estimates of between-laboratory precision are acceptable and the method is used extensively in the trade for acceptance testing. 5.2.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is statistical bias between them using competent statistical assistance. As a minimum, use test samples for such comparative tests that are as homogeneous as possible, drawn form the same lot of material as the samples that resulted in the disparate results during initial testing, and that are randomly assigned in equal numbers to each laboratory for testing. The test results from the laboratories should be compared using a statistical test for unpaired data at a probability level chosen prior to the testing series. If a bias is found either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the know bias. |
||||||||||||||||
| 1. Scope | ||||||||||||||||
|
1.1 This test method describes the measurement of the number of binding sites per unit length or width of machine-made, woven, knitted, and tufted pile yarn floor covering both before and after adhesive backing application. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 Determination of the number of binding sites per unit length or width of pile floor covering previously was contained within Test Methods D418. 1.4 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
|
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Similar standards:
Historical
1.7.2013
Historical
1.6.2010
Historical
1.2.2012
Historical
1.2.2012
Historical
1.1.2011
Historical
1.5.2010
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
