Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D6287-17
Standard Practice for Cutting Film and Sheeting Test Specimens
Translate name
STANDARD published on 15.12.2017
The information about the standard:
Designation standards: ASTM D6287-17
Publication date standards: 15.12.2017
SKU: NS-807823
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D6287-17 :
Keywords:
film, sample preparation, sheeting,, ICS Number Code 25.100.01 (Cutting tools in general)
Additional information
| Significance and Use | ||||||
|
3.1 Many test methods including Test Methods D882, D2838, F88, F1921/F1921M, and F2029 require the use of narrow strips of varying length. The quality of the sample preparation directly affects test results. This practice describes three techniques for preparing samples with straight, clean, parallel edges with no visible imperfections. Note 2: After cutting, each specimen should be examined
visually to insure the edges are undamaged (free of nicks). On a
periodic basis specimen edge quality should be evaluated by
microscopic examination. To determine when cutting blades need to
be replaced or sharpened, a control chart of tensile strength and
percent elongation at break (see Test Method D882) of a uniform material may be
maintained. Tensile strength and percent elongation at break will
decrease as the quality of specimen cutting decreases.
|
||||||
| 1. Scope | ||||||
|
1.1 This practice covers equipment and techniques for cutting film and sheeting specimens for testing.1.2 The values given in SI units are to be considered standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this
standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
