ASTM D6468-08(2013)..
ASTM D6469-12
ASTM D6550-10
ASTM D6596-00(2011)..
ASTM D6615-14a
ASTM E2154-01(2008)..
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D6426-13
Standard Test Method for Determining Filterability of Middle Distillate Fuel Oils
STANDARD published on 1.7.2013
The information about the standard:
Designation standards: ASTM D6426-13
Note: WITHDRAWN
Publication date standards: 1.7.2013
SKU: NS-35103
The number of pages: 6
Approximate weight : 18 g (0.04 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D6426-13 :
Keywords:
aviation turbine fuels, distillate fuels, filterability, fuel cleanliness, fuel filterability, gas oils, middle distillate fuel, particulates in fuel, ICS Number Code 27.060.10 (Liquid and solid fuel burners)
Additional information
| Significance and Use | ||||||||||||||||
|
5.1 This test method is intended for use in the laboratory or field in evaluating distillate fuel cleanliness. 5.2 A change in filtration performance after storage, pretreatment, or commingling can be indicative of changes in fuel condition. 5.3 Relative filterability of fuels may vary depending on filter porosity and structure and may not always correlate with results from this test method. 5.4 Causes of poor filterability in industrial/refinery filters include fuel degradation products, contaminants picked up during storage or transfer, incompatibility of commingled fuels, or interaction of the fuel with the filter media. Any of these could correlate with orifice or filter system plugging, or both. |
||||||||||||||||
| 1. Scope | ||||||||||||||||
|
1.1 This test method covers a procedure for determining the filterability of distillate fuel oils within the viscosity range from 1.70 to 6.20 mm2/s (cSt) at 40°C. 1.2 This test method is not
applicable to fuels that contain undissolved water.
1.3 The values stated in SI units are to be regarded as standard. 1.3.1 Units of pressure are also provided in inch-pound for information. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Similar standards:
Historical
1.10.2013
Historical
1.11.2012
Historical
1.10.2010
Historical
1.5.2011
Historical
15.5.2014
Historical
1.2.2008
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
