ASTM C1536-10
ASTM C1589/C1589M-14..
ASTM C1620-12
ASTM C1642-07
ASTM C1643-14
ASTM C1735-11
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D6622-01(2009)
Standard Guide for Application of Fully Adhered Hot-Applied Reinforced Waterproofing Systems
STANDARD published on 1.1.2009
The information about the standard:
Designation standards: ASTM D6622-01(2009)
Note: WITHDRAWN
Publication date standards: 1.1.2009
SKU: NS-35927
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D6622-01(2009) :
Keywords:
application, asphalt, coal tar pitch, modified bitumen, polymer-modified bitumen sheet, rubberized asphalt waterproofing, waterproofing, Application--roofing/waterproofing material, Fully-adhered waterproofing systems, Reinforced roofing/waterproofing materials, Waterproofing materials/applications, ICS Number Code 91.100.50 (Binders. Sealing materials)
Additional information
| Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
This guide outlines general procedures and precautions for the application of fully adhered hot-applied built-up reinforced waterproofing systems. This guide is not all inclusive and is intended only to supplement detailed instructions from designers, and the recommendations of manufacturers. Manufacturers of some of the systems addressed by this guide require proprietary products and special procedures not described in this guide. Manufacturers' recommendations should therefore be considered in the application of this guide. For design guidelines, consult Guide C 981. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This guide covers the minimum installation recommendations for fully adhered, hot-applied reinforced waterproofing systems on vertical and low-slope (plaza deck) surfaces. 1.2 For the purpose of this guide, the substrate is assumed to be concrete or masonry, structurally sound, able to accept the weight of anticipated loads, and meets the local building code requirements. Similarly, all components of the waterproofing system are assumed to comply with any federal, state, and local environmental regulations that may be in effect at the time of installation. Expansion joints, insulation, drainage layers, and overburden are beyond the scope of this guide. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Similar standards:
Historical
1.6.2010
Historical
1.4.2014
Historical
1.6.2012
Historical
1.7.2007
Historical
1.6.2014
Historical
15.8.2011
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
