Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D6818-21
Standard Test Method for Tensile Properties of Rolled Erosion Control Products
Translate name
STANDARD published on 15.2.2021
The information about the standard:
Designation standards: ASTM D6818-21
Publication date standards: 15.2.2021
SKU: NS-1018259
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D6818-21 :
Keywords:
breaking force, elongation, rolled erosion control products,, ICS Number Code 83.120 (Reinforced plastics)
Additional information
| Significance and Use | ||||||||
|
5.1?The strip test in this test method is considered satisfactory for acceptance testing (that is, conformance to a specification) of commercial shipments of rolled erosion control products, since the method has been used extensively in the trade for acceptance testing. 5.1.1?In case of disagreement arising from differences in reported test values when using this test method for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. At a minimum, the two parties should take a group of test specimens which are as homogeneous as possible and are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Student's t-test for unpaired data and an acceptable probability level chosen by the two parties before testing is begun. If bias is found, either its cause must be found and corrected, or the purchaser and the supplier must agree to interpret future results in the light of the known bias. |
||||||||
| 1. Scope | ||||||||
|
1.1?This test method covers strip test procedures for determining the tensile properties of rolled erosion control products (RECPs). 1.2?The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only. 1.3?This standard does not apply to RECPs made of composite materials where the component providing the reinforcement cannot be tested for tensile strength with the procedure herein described. In this case, the established ASTM testing method which is most appropriate for that material shall be used instead. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
| 2. Referenced Documents | ||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
