Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D7113/D7113M-10(2016)
Standard Test Method for Density of Bituminous Paving Mixtures in Place by the Electromagnetic Surface Contact Methods
STANDARD published on 1.5.2016
The information about the standard:
Designation standards: ASTM D7113/D7113M-10(2016)
Note: WITHDRAWN
Publication date standards: 1.5.2016
SKU: NS-637680
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D7113/D7113M-10(2016) :
Keywords:
bituminous-concrete density, density, in-place density, non-nuclear test method, electronic density device ,, ICS Number Code 93.080.20 (Road construction materials)
Additional information
| Significance and Use | ||||||||||||||
|
3.1 The test method described is useful as a rapid, nondestructive technique for determining the in-place density or relative compaction of compacted bituminous mixtures. 3.2 The test method can be used to establish the proper rolling effort and pattern to achieve the required density. 3.3 The non-destructive nature of the test allows repetitive measurements to be made at a single test location between roller passes or at multiple locations across the mat to monitor changes in density. 3.4 The density results obtained by this test method are relative. Device calibration (correlation with other test methods] is required to convert the results obtained using this method to actual density. Section 6 of this test method describes a method that has proven to be acceptable for correlation. Note 1: The personnel and equipment used in performing this
test can be evaluated in accordance with Specification D3666.
Note 2: Research and evaluation of devices used in this test
method has been conducted. Reference is made to “Evaluation of
Non-Nuclear Gauges to Measure Density of Hot-Mixed Asphalt
Pavements,” a pooled fund study, Pedro Romero, Ph.D., P.E., July
2002.
|
||||||||||||||
| 1. Scope | ||||||||||||||
|
1.1 This test method covers the procedures for determining the in-place density and relative compaction of bituminous concrete pavement paving mixtures by an electromagnetic surface contact device by measuring changes in the electromagnetic field resulting from the compaction process. 1.2 The equipment referenced in this method is a surface contact device, which must accommodate surface moisture and temperature variation in the range typically encountered in paving applications. This can be accomplished by design parameters that reduce the device’s sensitivity to surface moisture and temperature variation or by measurements and algorithms to account for surface moisture and temperature variance in the rolling pattern. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices prior to use. |
||||||||||||||
| 2. Referenced Documents | ||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
