We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Method for Sulfated Ash from Lubricating Oils and Additives
STANDARD published on 10.1.2000
Designation standards: ASTM D874-00
Note: WITHDRAWN
Publication date standards: 10.1.2000
SKU: NS-39560
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
additives, ash, lubricating oils, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
1. Scope | ||||||||||||||
1.1 This test method covers the determination of the sulfated ash from unused lubricating oils containing additives and from additive concentrates used in compounding. These additives usually contain one or more of the following metals: barium, calcium, magnesium, zinc, potassium, sodium, and tin. The elements sulfur, phosphorus, and chlorine can also be present in combined form. 1.2 Application of this test method to sulfated ash levels below 0.02 mass% is restricted to oils containing ashless additives. The lower limit of the method is 0.005 mass% sulfated ash. Note 1-This test method is not intended for the analysis of used engine oils or oils containing lead. Neither is it recommended for the analysis of nonadditive lubricating oils, for which Test Method D482 can be used. Note 2-There is evidence that magnesium does not react the same as other alkali metals in this test. If magnesium additives are present, the data is interpreted with caution. Note 3-There is evidence that samples containing molybdenum can give low results because molybdenum compounds are not fully recovered at the temperature of ashing.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 The values given in acceptable metric units are to be regarded as the standard. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-09-16 (Number of items: 2 433 731)
© Copyright 2024 NORMSERVIS s.r.o.