We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Method for Temperature Calibration of Thermomechanical Analyzers
STANDARD published on 10.3.2003
Designation standards: ASTM E1363-03
Note: WITHDRAWN
Publication date standards: 10.3.2003
SKU: NS-41501
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
calibration, temperature, thermal analysis, thermomechanical analysis
Significance and Use | ||||
Thermomechanical analyzers are employed in their various modes of operation (penetration, expansion, flexure, etc.) to characterize a wide range of materials. In most cases, the value to be assigned in thermomechanical measurements is the temperature of the transition (or event) under study. Therefore, the temperature axis (abscissa) of all TMA thermal curves must be accurately calibrated either by direct reading of a thermocouple or by adjusting the programmer temperature to match the actual temperature over the temperature range of interest. |
||||
1. Scope | ||||
1.1 This test method describes the temperature calibration of thermomechanical analyzers from -50 to 1100°C. (See Note 2.) 1.2 Computer or electronic based instruments, techniques, or data treatment equivalent to this test method may be used. Note 2Users of this test method are advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user of this test method to determine the necessary equivalency prior to use. 1.3 SI units are the standard. 1.4 This standard is similar to ISO 11359-1 but addresses a larger temperature range and utilizes additional calibration materials. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7 and Note 10. |
||||
2. Referenced Documents | ||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-08-27 (Number of items: 2 344 895)
© Copyright 2024 NORMSERVIS s.r.o.