We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Methods for Water Vapor Retarders Used in Contact with Earth Under Concrete Slabs, on Walls, or as Ground Cover
STANDARD published on 1.12.2005
Designation standards: ASTM E154-99(2005)
Note: WITHDRAWN
Publication date standards: 1.12.2005
SKU: NS-42114
The number of pages: 7
Approximate weight : 21 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
earth covers, flame-spread resistance, low-temperature flexibility, puncture-resistance testing, plastic-flow resistance, soil contact testing, tensile testing, ultraviolet light resistance, water-vapor retarder, water-vapor transmission testing
Significance and Use | ||||||||||||||||||||||||||||
In service, vapor retarders may be exposed to a variety of conditions, so no one test will provide evaluations related to performance for all exposures (refer to Guide E 241 and C 755). Neither will all test methods listed be necessary in all evaluations for specific exposures (see 16.2). Limitations—Prior to use and in service, vapor retarders may be exposed to a variety of conditions so no one test will provide evaluations related to performance for all exposures (refer to Guide E 241 and C 755). Neither will all tests be necessary in all evaluations for specific exposures. Consequently, the tests and required test results shall be agreed upon by the purchaser and the supplier (see 16.2). |
||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||
1.1 These test methods cover the determination of the properties of flexible membranes to be used as vapor retarders in contact with earth under concrete slabs, against walls, or as ground cover in crawl spaces. The test methods are applicable primarily to plastic films, and other flexible sheets. The materials are not intended to be subjected to sustained hydrostatic pressure. The procedures simulate conditions to which vapor retarders may be subjected prior to and during installation, and in service. 1.2 The test methods included are: SectionWater-Vapor Transmission of Material as ReceivedWater-Vapor Transmission after Wetting and Drying and after Long-Time SoakingTensile Strength Resistance to Puncture Resistance to Plastic Flow and Elevated Temperature Effect of Low Temperatures on Flexibility Resistance to Deterioration from Organisms and Substances in Con-tacting Soil Resistance to Deterioration from Petroleum Vehicles for Soil PoisonsResistance to Deterioration from Exposure to Ultraviolet Light Resistance to Flame Spread Report1.3 The values stated in acceptable metric units shall be considered standard. The values in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-07-20 (Number of items: 2 338 064)
© Copyright 2024 NORMSERVIS s.r.o.