ASTM E1612/E1612M-94(2013)e1

8.1.1 Without frames.

8.1.2 Without flanges and nosing material(s).

8.1.3 Used in interior or exterior applications.

8.1.4 Used in any construction of the building.

8.2.1 The physical properties of the fully cured elastomeric alloy.

8.2.2 The movement capability in relation to the nominal joint width as defined under Test Method E1399/E1399M.

8.4.1 Durability of the architectural compression seal under actual service conditions, including the effects of cycled temperature on the compression seal.

8.4.2 Loading capability of the system and the effects of a load on the functional parameters established by this specification.

8.4.3 Shear and rotational movements of the specimen.

8.4.4 Any other attributes of the specimen, such as fire resistance, wear resistance, chemical resistance, air infiltration, watertightness, and so forth.

8.4.5 Testing or compatibility of substrates.

8.4.6 Strip seals.

8.4.7 Architectural compression seals used with frames.

8.4.8 Architectural compression seals used with flanges and nosing material(s).

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.