Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM E498-95(2000)
Standard Test Methods for Leaks Using the Mass Spectrometer Leak Detector or Residual Gas Analyzer in the Tracer Probe Mode
STANDARD published on 10.7.2000
The information about the standard:
Designation standards: ASTM E498-95(2000)
Note: WITHDRAWN
Publication date standards: 10.7.2000
SKU: NS-46988
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM E498-95(2000) :
Keywords:
Bell jar leak test, Bomb mass spectrometer leak test, Helium leak testing, Leak testing, Leak testing-mass spectrometer leak detector (MSLD), Mass spectrometer leak detector (MSLD), Mass spectrometry, Probe methods, Residual gas analyzer (RGA), Tracer probe mode, Vacuum testing, leak detection-using the mass spectrometer leak detector/residual gas, analyzer in the tracer probe mode, test,, Sealed object mass spectrometer leak test
Additional information
| 1. Scope | ||||
|
1.1 These test methods cover procedures for testing and locating the sources of gas leaking at the rate of 4.5 X 10 -14 mol/s (1 X 10 -9 Std cm3/s) or greater. The test may be conducted on any object to be tested that can be evacuated and to the other side of which helium or other tracer gas may be applied. 1.2 Three test methods are described: 1.2.1 Test Method A -For the object under test capable of being evacuated, but having no inherent pumping capability. 1.2.2 Test Method B -For the object under test with integral pumping capability. 1.2.3 Test Method C -For the object under test as in Test Method B, in which the vacuum pumps of the object under test replace those normally used in the leak detector. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific hazard statement can be found in 19.2. |
||||
| 2. Referenced Documents | ||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
