Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM E955-88(2009)e1
Standard Test Method for Thermal Characteristics of Refuse-Derived Fuel Macrosamples (Withdrawn 2017) (Includes all amendments And changes 9/6/2017).
Automatically translated name:
Standard Test Method for Thermal Characteristics of Refuse-Derived Fuel Macrosamples
STANDARD published on 1.9.2009
The information about the standard:
Designation standards: ASTM E955-88(2009)e1
Note: WITHDRAWN
Publication date standards: 1.9.2009
SKU: NS-48589
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM E955-88(2009)e1 :
Keywords:
Combustible material, Heating tests--refuse-derived fuel/waste, Moisture analysis--refuse-derived fuel/RDF, Noncombustible matter content, Refuse-derived fuel (RDF), Thermal transmission properties, ICS Number Code 75.160.10 (Solid fuels)
Additional information
| Significance and Use | ||||
|
This test method is available to producers and users of RDF as a means of determining thermal characteristics of a large sample of RDF without extensive processing of the laboratory sample. It is intended that the results obtained be used to monitor changes in the fuel characteristics of RDF over a period of time. |
||||
| 1. Scope | ||||
|
1.1 This test method covers the determination of moisture, noncombustibles and combustibles, and the calculation of higher heating value content of a large mass of refuse-derived fuel-three (RDF). 1.2 This test method may be applicable to any waste material, including residues from combustion, from which a representative sample can be prepared. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 7 for additional hazard information. |
||||
| 2. Referenced Documents | ||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
