Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F1412-01
Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
STANDARD published on 10.4.2001
The information about the standard:
Designation standards: ASTM F1412-01
Note: WITHDRAWN
Publication date standards: 10.4.2001
SKU: NS-50200
The number of pages: 6
Approximate weight : 18 g (0.04 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM F1412-01 :
Keywords:
acid waste, corrosion resistance, corrosive waste, drainage, drain pipes, installation, joints, laboratory piped services, pipe fittings, pipes, plastic pipes, polyethylene, polyolefin, polypropylenes, thermoplastic polymers, traps (drainage), waste disposal (building)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers requirements for nonpressure polyolefin pipe and fittings for corrosive waste drainage systems. 1.2 This specification is a companion to the Canadian Standard, CAN/CSA-B181.3. 1.3 Pipe is produced in Schedule 40 and 80 IPS sizes in two polyolefins, polyethylene (PE) and polypropylene (PP). 1.4 The interchangeability of pipe and fittings made by different manufacturers is not addressed in this specification. Transition fittings for joining pipe and fittings of different manufacturers is provided for in this specification. 1.5 Pipe and fittings are joined by the heat fusion method or by using mechanical joints recommended by the manufacturer. 1.6 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only. 1.7 The following safety hazards caveat pertains only to the test method, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
