Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F2181-09
Standard Specification for Wrought Seamless Stainless Steel Tubing for Surgical Implants
STANDARD published on 1.2.2009
The information about the standard:
Designation standards: ASTM F2181-09
Note: WITHDRAWN
Publication date standards: 1.2.2009
SKU: NS-53104
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM F2181-09 :
Keywords:
metals (for surgical implant), seamless tubing, stainless steel, surgical applications tubing, surgical implants, Stainless steel surgical applications--specifications, Surgical applications tubing, Surgical implants--specifications, Wrought surgical implant materials--specifications, ICS Number Code 11.040.40 (Implants for surgery, prothetics and orthotics)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||
|
1.1 This specification covers the requirements for five compositions of wrought seamless stainless steel tubing for the manufacture of surgical implants. Material shall conform to the applicable requirements of Specifications F 138, F 1314, F 1586, F 2229, or F 2581. This specification addresses those product variables that differentiate wrought seamless tubing from the bar and wire product forms covered in these specifications. 1.2 This specification applies to cold finished, straight length tubing from 3 to 34 mm (0.125 to 1.315 in.) nominal outside diameter (OD) and 0.5 mm (0.020 in.) and greater nominal wall thickness. 1.3 The specifications in 2.1 are referred to as the ASTM material standard(s) in this specification. 1.4 The values stated in either inch-pound or SI units are to be regarded separately as standard. Inch-pound units are shown in parentheses. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
