Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F2648/F2648M-11
Standard Specification for 2 to 60 inch [50 to 1500 mm] Annular Corrugated Profile Wall Polyethylene (PE) Pipe and Fittings for Land Drainage Applications
STANDARD published on 1.8.2011
The information about the standard:
Designation standards: ASTM F2648/F2648M-11
Note: WITHDRAWN
Publication date standards: 1.8.2011
SKU: NS-54308
The number of pages: 8
Approximate weight : 24 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM F2648/F2648M-11 :
Keywords:
Profile wall, interior liner, pipe, fittings, PE, subdrainage, land drainage, polyethylene Corrugated wall, Land drainage piping systems, Pipe fittings--PE (polyethylene), Polyethylene (PE)--specifications, Polyethylene (PE) pipe--specifications, Profile wall, ICS Number Code 65.060.35 (Irrigation and drainage equipment)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers requirements and test methods for annular corrugated profile wall polyethylene pipe and fittings with an interior liner. The inside diameters covered are 2 to 60 in. [50 to 1500 mm]. 1.2 The requirements of this specification are intended to provide non-pressure (gravity flow) pipe and fittings suitable for underground use for subsurface and land drainage systems, which do not operate under surcharge pressure heads. Note 1—Pipe and fittings produced in accordance with this specification are be installed in compliance with Practice D2321 or Practice F449 based on diameter limitations within the respective standards. Note 2—Subsurface and land drainage systems pertain principally to non-municipal or private facilities for water table control, storm drainage and agricultural drainage applications. The products supplied under this specification are not intended for any sanitary sewer or municipal storm sewer applications. 1.3 This specification covers pipe and fittings with an interior liner using an annular exterior corrugated profile (Fig. 1). 1.4 This specification permits the use of recycled materials for pipe in accordance with the requirements in Section 5. 1.5 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
