We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Guide for Conducting Small Boat Stability Test (Deadweight Survey and Air Inclining Experiment) to Determine Lightcraft Weight and Centers of Gravity of a Small Craft
STANDARD published on 1.1.2014
Designation standards: ASTM F3052-14
Note: WITHDRAWN
Publication date standards: 1.1.2014
SKU: NS-54899
The number of pages: 20
Approximate weight : 60 g (0.13 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
ICS Number Code 47.080 (Small craft)
Significance and Use | ||
4.1 From the lightcraft characteristics, calculations of the stability characteristics of the small craft for all load conditions can determine compliance to applicable stability criteria or provide mass properties information for other analyses or investigations. Accurate results from an air incline stability test may therefore determine future survival of the boat, the crew and compliment. If the small craft is not 100 % complete or there is fuel or other liquids in a tank that is supposed to be clean and dry then the person leading the stability test must determine the acceptability of all variances from the guide based on the ability to correct for these variances analytically. A complete understanding of the principles behind the stability test and knowledge of the factors that affect the results is therefore necessary. 4.2 The results of the stability test typically supersede the corresponding values in the weight estimate for any subsequent use in ascertaining compliance to stability or weight control criteria and may be used in weight margin adjudication. |
||
1. Scope | ||
1.1 This guide covers the determination of a small boat’s lightcraft characteristics. The air incline stability test can be considered two separate tasks; a deadweight survey and an air-inclining experiment. The stability test is recommended, but not required, for all small craft upon their construction completion and/or after major conversions where stability information is required. It is typically conducted indoors and an enclosed facility to protect the vessels from unprotected environmental conditions. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historical
1.3.2014
Historical
1.7.2012
Historical
1.3.2011
Historical
15.8.2006
Historical
15.4.2007
Historical
15.4.2007
Latest update: 2024-12-22 (Number of items: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.