ASTM D2661-11
ASTM D2665-14
ASTM D2680-01(2009)..
ASTM D2729-11
ASTM D2737-12a
ASTM D2774-12
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F877-11a
Standard Specification for Crosslinked Polyethylene (PEX) Hot- and Cold-Water Distribution Systems (Includes all amendments And changes 4/18/2018).
Automatically translated name:
Standard Specification for Crosslinked Polyethylene (PEX) Hot- and Cold-Water Distribution Systems
STANDARD published on 1.8.2011
The information about the standard:
Designation standards: ASTM F877-11a
Note: WITHDRAWN
Publication date standards: 1.8.2011
SKU: NS-56770
The number of pages: 7
Approximate weight : 21 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM F877-11a :
Keywords:
Cold water supply/distribution systems--specifications, Crosslinked polyethylene (PEX) pipe/tube--specifications, Cycling, Failure end point--plastics, Hot water supply/distribution systems--specifications, Polyethylene (PE) tube--specifications, Thermal cycling test, Water supply/distribution systems--specifications, ICS Number Code 23.040.20 (Plastic pipes)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers requirements, test methods, and marking requirements for system components when tested with nominal SDR9 crosslinked polyethylene tubing as a system. Systems are intended for 100 psi (0.69 MPa) water service up to and including a maximum working temperature of 180°F (82°C). Requirements and test methods are included for materials, workmanship, dimensions and tolerances, burst pressure, sustained pressure, excessive temperature and pressure, and thermo-cycling tests. The components covered by this specification are intended for use in residential and commercial, hot and cold, potable water distribution systems or other applications such as municipal water service lines, radiant panel heating systems, hydronic baseboard heating systems, snow and ice melting systems, and building services pipe. 1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification. 1.3 The values stated in inch-pound units are to be regarded as the standard. The values stated in parentheses are provided for information only. Note 1—Suggested hydrostatic design stresses and hydrostatic pressure ratings for tubing and fittings are listed in Appendix X1. Design, assembly, and installation considerations are discussed in Appendix X2. An optional performance qualification and an in-plant quality control program are recommended in Appendix X3. 1.4 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
Similar standards:
Historical
1.8.2011
Historical
1.5.2014
Historical
1.3.2009
Historical
1.2.2011
Historical
1.11.2012
Historical
1.2.2012
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
