ASTM F480-14
ASTM F481-97(2008)..
ASTM F512-12
ASTM F585-13
ASTM F610/F610M-10..
ASTM F628-12e1
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D2924-12
Standard Test Method for External Pressure Resistance of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe
STANDARD published on 1.10.2012
The information about the standard:
Designation standards: ASTM D2924-12
Note: WITHDRAWN
Publication date standards: 1.10.2012
SKU: NS-21981
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D2924-12 :
Keywords:
external pressure resistance, fiberglass pipe, pipe, reinforced polymer mortar pipe (RPMP), reinforced thermosetting-resin pipe (RTRP), ICS Number Code 23.040.20 (Plastic pipes)
Additional information
| Significance and Use | ||||||||||
|
5.1 The values obtained by this test method are applicable only to conditions that specifically duplicate the procedures used. 5.2 After a scaling constant is determined for one diameter, this may be used for calculating the external failure pressures of other diameters as long as the resin and reinforcement (if used), the wall thickness-to-diameter ratio, and the reinforcement pattern (if reinforcement is used) are the same. 5.3 In the application of the
following test requirements and recommendations, care must be
exercised to ensure that the specimens tested are truly
representative of the group being studied.
|
||||||||||
| 1. Scope | ||||||||||
|
1.1 This test method covers determination of the resistance of fiberglass pipe to external pressure. It classifies failures as buckling, compressive, and leaking. Both glass-fiber-reinforced thermosetting-resin pipe (RTRP) and glass-fiber-reinforced polymer mortar pipe (RPMP) are fiberglass pipes. 1.2 The values stated in inch-pound
units are to be regarded as standard. The SI units given in
parentheses are for information only.
1.3 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
|
||||||||||
| 2. Referenced Documents | ||||||||||
|
Similar standards:
Historical
1.3.2014
Historical
1.7.2008
Historical
1.8.2012
Historical
1.8.2013
Historical
15.4.2010
Historical
15.11.2012
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
