We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Method for Performance of Drawer Warmers
STANDARD published on 1.6.2013
Designation standards: ASTM F2142-01(2013)
Note: WITHDRAWN
Publication date standards: 1.6.2013
SKU: NS-52968
The number of pages: 8
Approximate weight : 24 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
drawer warmer, holding energy, idle energy consumption, preheat time and energy consumption, temperature uniformity, ICS Number Code 97.040.50 (Small kitchen appliances)
Significance and Use | ||
5.1 The energy input rate and thermostat calibration tests are used to confirm that the drawer warmer is operating properly prior to further testing. 5.2 Preheat energy and time can be useful to food service operators to manage energy demands and to know how quickly the drawer warmer can be ready for operation. 5.3 Idle energy rate and holding energy rate can be used by the food service operator to estimate energy consumption during operating periods and to consider energy consumption when choosing a drawer warmer. 5.4 The drawer pan temperature and drawer pan temperature uniformity can be used by an operator to choose a drawer warmer which meets their food holding needs. |
||
1. Scope | ||
1.1 This test method evaluates the preheat, idle, and holding energy consumption and temperature uniformity of drawer warmers. The food service operator can use this evaluation to select a drawer warmer and understand its energy performance and temperature uniformity. A drawer warmer is described as a commercial kitchen appliance that consists of one or more heated drawers and which is used to hold hot food (usually no greater than 200°F) that has been cooked in a separate appliance, at a specified temperature. 1.2 This test method is applicable to freestanding and built-in electric drawer warmers equipped for: 1.2.1 Industry-standard 12 × 20 × 6–in. (nominal size) pans, or 1.2.2 Standard-oversized 15 × 20 × 5–in. (nominal size) pans. 1.3 The drawer warmer can be evaluated with respect to the following (where applicable): 1.3.1 Energy input rate (1.3.2 Energy consumption rate at maximum setting (1.3.3 Temperature calibration (1.3.4 Preheat energy consumption and time (1.3.5 Idle energy rate (10.5), 1.3.6 Holding energy rate (1.3.7 Temperature uniformity (1.4 The values stated in inch-pound units are to be regarded as standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historical
1.6.2013
Historical
1.3.2010
Historical
1.10.2011
Historical
1.10.2011
Historical
1.4.2014
Historical
1.11.2012
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-12-22 (Number of items: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.